Correct Answer: C
A default route is a special type of route that specifies where to send packets when there is no explicit route for the destination in the routing table. A default route is usually configured on a router or a gateway that connects to another network, such as the internet. A default route is often represented by the destination 0.0.0.0/0, which means any IP address.
A default route is not always used first. It is only used as a last resort, when there is no more specific route for the destination. For example, if a host wants to send a packet to 192.168.1.10, and the routing table contains the following entries:
Destination Gateway Genmask Flags Metric Ref Use Iface 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0
0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0
The host will use the first entry, which is more specific, and send the packet directly to 192.168.1.10 via eth0 interface. The second entry, which is the default route, will not be used in this case. However, if the host wants to send a packet to 8.8.8.8, which is not in the same network, the host will use the default route and send the packet to 192.168.1.1, which is the gateway to the internet.
Setting a default route does not disable other routes. It only adds an entry to the routing table that can be used when no other route matches the destination. Other routes are still valid and can be used if they are more specific.
Without a default route, network communication in directly attached networks is still possible, as long as there are routes for those networks in the routing table. However, network communication to other networks that are not directly connected will not be possible, unless there are specific routes for those networks in the routing table.
References:
* How to Set the Default Gateway in Linux - How-To Geek
* Linux setup default gateway with route command - nixCraft
* How to set a default route permanently in Linux - Xmodulo
