The command ifconfig can be used to set a network interface active or inactive by using the up or down options. For example, the following command will activate the eth0 interface:
sudo ifconfig eth0 up
The command ifconfig can also be used to change the netmask used on a network interface by specifying the netmask option followed by the desired netmask value. For example, the following command will change the netmask of the eth0 interface to 255.255.255.0:
sudo ifconfig eth0 netmask 255.255.255.0
The other options in the question are not possible with the ifconfig command. The command ifconfig cannot specify the kernel module to be used with a network interface. This is done by the modprobe command or the
/etc/modules file. The command ifconfig cannot allow regular users to change the network configuration of a network interface. This is controlled by the sudoers file or the polkit framework. The command ifconfig cannot specify which network services are available on a network interface. This is done by the firewall rules or the /etc/services file. References:
* [LPI Linux Administrator - Exam 102 Objectives - Topic 109: Networking Fundamentals]
* Linux ifconfig Command | Linuxize
* 15 Useful "ifconfig" Commands to Configure Network in Linux - Tecmint
* ifconfig command in Linux with Examples - GeeksforGeeks

The Hop Limit field in the IPv6 header is similar to the Time to Live (TTL) field in the IPv4 header. It specifies the maximum number of hops (routers) that a packet can traverse before reaching its destination. Each router that receives the packet decrements the Hop Limit field by one and forwards the packet. If the Hop Limit field reaches zero, the packet is discarded and an ICMPv6 error message is sent back to the source. This mechanism prevents packets from looping indefinitely in the network12 Reference: 1: IPv6 packet - Wikipedia 2: IP Time to Live (TTL) and Hop Limit Basics - Packet Pushers

/etc/mail/aliases