Online Access Free 156-315.81 Practice Test

After trust has been established between the Check Point components, what is TRUE about name and IP- address changes?

• A.The Security Gateway name cannot be changed in command line without re-establishing trust.
• B.The Security Management Server IP-address cannot be changed without re-establishing the trust.
• C.Security Gateway IP-address cannot be changed without re-establishing the trust.
• D.The Security Management Server name cannot be changed in SmartConsole without re-establishing trust.

Bob has finished io setup provisioning a secondary security management server. Now he wants to check if the provisioning has been correct. Which of the following Check Point command can be used to check if the security management server has been installed as a primary or a secondary security management server?

• A.cpprod_util FwlsPrimary
• B.cpprod_util FwlsSecondary
• C.cpprod_util MgmtlsSecondary
• D.cpprod_util MgmtlsPrimary

IF the first packet of an UDP session is rejected by a rule definition from within a security policy (not including the clean up rule), what message is sent back through the kernel?

• A.TCP RST
• B.ICMP unreachable
• C.Nothing
• D.TCP FIN

What should the admin do in case the Primary Management Server is temporary down?

• A.Logon with SmartConsole to the Secondary Management Server and choose "Make Active' under Actions in the HA Management Menu
• B.Use the VIP in SmartConsole you always reach the active Management Server.
• C.The Secondary will take over automatically Change the IP in SmartConsole to logon to the private IP of the Secondary Management Server.
• D.Run the 'promote_util' to activate the Secondary Management server

Which command is used to set the CCP protocol to Multicast?

• A.cphaprob set_ccp no_broadcast
• B.cphaconf set_ccp multicast
• C.cphaprob set_ccp multicast
• D.cphaconf set_ccp no_broadcast