Online Access Free 156-836 Practice Test

Which command is used to set the number of sites in a Maestro environment?

• A.set maestro configuration orchestrator-site-id
• B.set maestro configuration orchestrator-site-number
• C.set maestro configuration orchestrator-site-amount
• D.set maestro orchestrator-site-amount

Common Layer 1 issues include

• A.Loose or bad cables
• B.Distribution
• C.Routing
• D.MAC addresses

Splitter cannot be used _______

• A.To connect single port on Appliance to multiple ports on the orchestrator
• B.To connect single port on orchestrator to multiple port on external switch
• C.To connect single port on orchestrator to the same Appliance
• D.To connect single port on orchestrator to multiple Appliances

When a VPN tunnel is formed with a Maestro SGM,

• A.The MHO handles the IKE before distributing the traffic to a SGM to handle all encrypted traffic. This helps to prevent any issues with the correction layer.
• B.SGM 1 analyzes the policy and topology. If encryption is required, it calculates the tunnel owner's IP address. SGM 1 sends a clear packet to the tunnel owner. SGM 2 is now the connection and tunnel owner.
• C.The MHO distributes copies of the packets to two different SGMs because SGM 1 will handle the clear traffic IKE exchange packets, while SGM2 handles encrypted packets.
• D.The receiving SGM makes an encryption decision. The SGM then syncs the traffic to two backup SGMs: one for clear traffic and one for encrypted traffic.

What is the purpose of interface bonding?

• A.A bond interface can be configured for high availability redundancy or for load sharing which increases connection throughput above that which is possible using one physical interface.
• B.For load sharing which increases connection throughput above that which is possible using one physical interface.
• C.A bond interface can be configured for high availability redundancy.
• D.A bond interface is used for passing synchronization traffic between the SGMs.