Online Access Free 1Y0-230 Practice Test

Scenario: A Citrix ADC receives packets that are destined for a MAC address owned by the Citrix ADC.
The destination IP address of the packets does not belong to the Citrix ADC.
Layer 3 Mode is enabled by default on the Citrix ADC.
What will the Citrix ADC do with the packets in this scenario?

• A.Process the packets
• B.Bridge the packets.
• C.Route the packets.
• D.Drop the packets

Scenario: Users belong to three Authentication, Authorization and Auditing (AAA) groups:
Corporate, Finance and Software.
show aaa groups:
> show aaa group
1. GroupName: Corporate
2. GroupName: Finance
3. GroupName: Software
Done
> show aaa group Corporate
GroupName: Corporate
Weight: 0
Authorization Policy: pol_1, Type: Classic, Priority: 0
> add authorization policy pol_1 ns_true ALLOW
> bind aaa group Corporate -policy pol_1
The user is being denied resources while aaad.debug shows:
Group 'corporate' being extracted for user User1
Why is the user being denied access?

• A.LDAP Base DN is incorrect.
• B.AAA group names are NOT the same as those in Active Directory.
• C.The group attribute is NOT configured in the LDAP policy.
• D.The Authorization policy is NOT configured property.

Scenario: A Citrix Administrator entered the command-line interface commands below to prevent IP address 10.10.10.100 from accessing the NetScaler on port 80.
add simpleacl rule1 DENY -srclP 10.10.10.100 -TTL 600
add simpleacl rule2 DENY -srclP 10.10.10.100 -destPort 80
add ns acl rule1 DENY -srclP 10.10.10.100 -priority 10
add ns acl rule2 DENY -srclP 10.10.10.100 -priority 100
apply ns acls
Which Access Control List (ACL) will the NetScaler use to deny the IP address?

• A.add ns acl rule2 DENY -srclP 10.10.10.100 -priority 100
• B.add simpleacl rule2 DENY -srclP 10.10.10.100 -destPort 80
• C.add simpleacl rule1 DENY -srclP 10.10.10.100 -TTL 600
• D.add ns acl rule1 DENY -srclP 10.10.10.100 -priority 10

A Citrix Administrator would like to define granular policies to configure and enforce user environment attributes for XenApp and XenDesktop on NetScaler Gateway.
Which type of policy would enable this requirement?

• A.Session
• B.SmartAccess
• C.SmartControl
• D.Authorization

Which option is needed to configure the NetScaler Gateway to provide users with multiple logon options after successful authentication, if the users are connected through clientless access?

• A.Client choices without using Endpoint Analysis
• B.Configuration of Quarantine Group
• C.Configuration of Endpoint Analysis
• D.Client choices options with mandatory Endpoint Analysis