Online Access Free 1Z0-050 Practice Test

Which of the following information will be gathered by the SQL Test Case Builder for the problems pertaining to SQL-related problems? (Choose all that apply.)

• A.ADR diagnostic files
• B.PL/SQL functions, procedures, and packages
• C.the table and index definitions and actual data
• D.all the optimizer statistics
• E.initialization parameter settings

View the Exhibit to examine the replay settings for replay parameters.
What is the implication for setting the values for replay parameters? (Choose all that apply.)

• A.The value 100 in the CONNECT_TIME_SCALE parameter attempts to connect all sessions immediately as soon as the replay begins.
• B.The value 100 in the THINK_TIME_SCALE parameter attempts to make the replay client shorten the think time between calls.
• C.The COMMIT order in the captured workload is preserved during replay.
• D.The value 100 in the THINK_TIME_SCALE parameter attempts to match the captured user think time while replaying.
• E.The value 100 in the CONNECT_TIME_SCALE parameter attempts to connect all sessions as captured.

Observe the following warning in an RMAN session of your database instance:
WARNING: new failures were found since last LIST FAILURE command
Which statement describes the scenario that must have produced this warning?

• A.The VALIDATE DATABASE command has detected new failures recorded in the Automatic Diagnostic Repository (ADR).
• B.The RECOVER command has detected new failures recorded in the Automatic Diagnostic Repository (ADR) since the last LIST FAILURE command was executed.
• C.The ADVISE FAILURE command has detected new failures recorded in the Automatic Diagnostic Repository (ADR) since the last LIST FAILURE
• D.The CHANGE FAILURE command has detected new failures recorded in the Automatic Diagnostic Repository (ADR).

Which statement about the enabling of table compression in Oracle Database 11g is true?

• A.Compression can be enabled at the table, tablespace, or partition level for conventional DML only.
• B.Compression can be enabled at the table, tablespace, or partition level for both direct loads and conventional DML.
• C.Compression can be enabled at the table, tablespace, or partition level for direct loads only.
• D.Compression can be enabled only at the table level for both direct loads and conventional DML.

View the Exhibit to examine the parameter values.

You are planning to set the value for the MEMORY_TARGET parameter of your database instance. What value would you assign?

• A.1440 MB
• B.272 MB
• C.90 MB
• D.362 MB