Online Access Free 1Z0-1075 Practice Test

A Work Center created a month ago is no longer in use now. You want to remove the Work Center; however,
the system is no allowing you to delete it.
Identify three reasons for this.

• A.The Work Center is being referenced in the Open Work Order.
• B.There are resources associated with the Work Center.
• C.The work center is being references in the work definition operation.
• D.The work center is being referenced in the Work Area.
• E.The Work Center is being referenced in the Closed Work Order.

In a manufacturing plant, the work definition and rate plans of Material, Resource, and Overhead of an
assembly have been defined as required.
A cost accountant created different scenarios to represent different manufacturing and cost assumptions and
compare the results. When the cost assumptions are finalized, the cost accountant is expected to publish the
cost scenario to cost accounting.
Identify three process steps that the cost accountant has to perform to transfer the assembly to cost accounting
in frozen type.

• A.Transfer Transactions from Inventory to Costing.
• B.Build cost planning scenario and perform cost roll up.
• C.Define a cost planning scenario with Material, Resource, Overhead cost plans, and work definition.
• D.Transfer transactions from production to Costing.
• E.Publish cost planning scenario to Accounting.
• F.Create Accounting Distributions.

A Manufacturing Engineer in a plant is creating an alternative manufacturing process for an item using its
existing Work Definitions. After copying from the existing Work Definition WD1 to the alternative Work
Definition WD2, the engineer finds that the operation items were not copied in the alternative manufacturing
process WD2.
Identify the reason.

• A.The Production Priority was not populated in the new Work Definition WD2 during creation.
• B.The Item and Structure Name in the existing Work Definition WD1 were retained in the new Work
  Definition WD2 as well during creation.
• C.The Item and Structure Name were changed in the new Work Definition WD2 during creation.
• D.The Start Data was not populated in the new Work Definition WD2 during creation.

While creating an item in Product Information Management (PIM), the following two item templates are
selected in sequence and applied.
1. Template: Finished Goods (WIP = No, Customer Ordered = Yes)
2. Template: Sub-assembly (WIP = Yes, Customer Ordered = No)
Identify the Item Attribute values in the application.

• A.WIP = No, Customer Ordered = Yes
• B.WIP = Yes, Customer Ordered = Yes
• C.WIP = No, Customer Ordered = No
• D.WIP = Yes, Customer Ordered = No

Planning Central has collected manufacturing data for a Work Order WO-2045 (Make Item AS1000), where
actual duration of work order is 2 days. Item AS1000 manufacturing lead time is 1.25 days.
A plan is run and the Work Order WO-2045 is rescheduled.
Identify the duration of the rescheduled Work Order WO- 2045.

• A.Rescheduled Work Order WO-2045 duration = 1.25 days
• B.Rescheduled Work Order WO-2045 duration = 3.25days
• C.Rescheduled Work Order WO-2045 duration = 0.75 days
• D.Rescheduled Work Order WO-2045 duration = 2 days