Online Access Free 1z1-404 Practice Test

Where are passwords and licensing information stored?

• A.Boot Flash
• B.Content Addressable Memory (CAM)
• C.Non-Volatile Random Access Memory (NVRAM)
• D.Synchronous Dynamic Random Access Memory (SDRAM)
• E.RAMmemory

You are configuring steering pools. After executing the done command, you get this error message:
error 409 saving configuration SteeringPool.
Identify the cause ofthe error.

• A.The ip-address parameter of the steering-pool has the same value as the address parameter of a sip-port configuration element.
• B.Another steering-pool configuration element with same ip-address and realm-id but with different start-port and end-port parameters values already exists in the configuration.
• C.Another steering-pool configuration element with same ip-address, realm-id, start-port, and end-port parameters values already exists in the configuration.
• D.The realm-id parameter value of the steering-pool refers to a realm-config element that already exists in the configuration.
• E.The realm-id parameter value of the steering-pool refers to a realm-config element that does not exist in the configuration.

Which two statements are correct about configuring realms and their corresponding interfaces? (Choose two.)

• A.You can configure more than one SIP interface per realm.
• B.You can associate multiple network interfaces with a single realm only when either TCP or UDP is used as the transport protocol.
• C.Although you can use both TCP and UDP concurrently as the transport protocol, you can only have one SIP interface per realm.
• D.You can associate multiple realms with a single networkinterface.
• E.You can associate multiple home realms with a single network interface.

You are configuring access rules in a Session Border Controller Peering architecture.
Which two configuration steps are required to allow access only from User Agents (UAs) in a specific IP subnet? (Choose two.)

• A.Navigate to the sip-port configuration element and set the allow-anonymous parameter to all.
• B.Navigate to therealm-config configuration element and set the addr-prefix parameter to the IP subnet of your trusted User Agents (UAs).
• C.Navigate to the sip-port configuration element and set the allow-anonymous parameter to agents-only.
• D.Navigate to the session-agent configuration element and set the ip-address parameter to the IP address of your trusted User Agent (UA).
• E.Navigate to the sip-port configuration element and set the allow-anonymous parameter to realm-prefix.

You configured theSession Agent Group (SAG) element. You want the Session Agent to be selected in the order in which they are listed in the destination list, with each agent selected in turn, one per session.
How would you accomplish this?

• A.Navigate to the session-agentconfiguration element and set the strategy parameter to sequential.
• B.Navigate to the session-agent configuration element and set the strategy parameter tohunt.
• C.Navigate to the session-agent configuration element and set the strategy parameter to leastbusy.
• D.Navigate to the session-agent configuration element and set the strategy parameter to propdist.
• E.Navigate to the session-agent configuration element and set the strategy parameter to roundrobin.