Online Access Free 1z1-429 Practice Test

Which four statements are true for CloneLUN and Volume Copy?

• A.CloneLUN is immediately accessible after it is created because it does not need to copy data.Volume Copy can be accessible only after the whole data copying is done.
• B.CloneLUN does not take space upfront but gradually requires more space when there are changes in the source data. Volume Copy needs the same amount of space as the source when created.
• C.When you need to refresh the data at target volume of Volume Copy service, the whole data must be copied.
• D.CloneLUN is read-only.
• E.You should choose Volume Copy when you really need to isolate performance impact among source and target volume.

After replacing the bad disk drive by using Guided Maintenance, what is the final step to complete the drive replacement?

• A.Click Complete in the guided maintenance wizard.
• B.No further steps are required.
• C.Click Finish in the guided maintenance wizard.
• D.Click Cancel in the guided maintenance wizard.

Which port on a Pilot is used for management access to the FS system?

• A.Net 3
• B.Net 1
• C.Net 2
• D.Net 0

Which two are recommended locations for Pilots and Controllers?

• A.Controller 1 in RU 23 and 24, Controller 2 in RU 25 and 26
• B.Pilot 1 in RU 21, Pilot 2 in RU 22
• C.Pilot 1 in RU 23, Pilot 2 in RU 24
• D.Controller 1 in RU 19 and 20, Controller 2 in RU 21 and 22

Which is the suggested component cabling sequence for a Not-Racked FS system?

• A.1. Pilot 1
  2.Pilot 2
  3.Controller 1
  4.Controller 2
  5.Des
• B.1. Pilot 2
  2.Pilot 1
  3.Controller 2
  4.Controller 1 5.Des
• C.1. Controller 1
  2.Controller 2
  3.Pilot 1
  4.Pilot 2
  5.Des
• D.1. Des
  2.Pilot 1
  3.Pilot 2
  4.Controller 1
  5.Controller 2
• E.1. Controller 2
  2.Controller 1
  3.Pilot 2
  4.Pilot 1
  5.DEs