Online Access Free 200-150 Practice Test

You need to configure an SVI on a Cisco Nexus 7000 Series switch. The interface is in VLAN 100 and the IP address must be 192.168 100.1 with a subnet mask of 255.255.255 0. Which configuration should you use?

• A.Option A
• B.Option C
• C.Option B
• D.Option D

Refer to the exhibit.

You are configuring an extended access list to permit a reply from Destination Server B to Source Host A for HTTP traffic. Which extended access list should you implement on the inbound interface of Router1?

• A.router(config)# permit tcp host 209.165.200.230 eq www host 209.165.202.130
• B.router(config)# permit tcp host 209.165.202.130 host 209.165.200.230 eq www
• C.router(config)# permit tcp host 209.165.202.130 eq www host 209.165.200.230
• D.router(config)# permit tcp host 209.165.200.230 host 209.165.202.130 eq www

Which option describes what a switch does after it learns that a host has connected to a switch port?

• A.Flood the frame only on all of its trunk ports.
• B.Flood the frame only on all of its access ports.
• C.Discard the frame.
• D.Create a MAC to port mapping entry in the MAC table.

Drag and drop the correct AAA security service on the left to its definition on the right.

Correct Answer:

Explanation
Authentication
Authorization
Accounting

To which component do you connect the Layer 1 port of a fabric interconnect?

• A.Layer 2 port of the opposite fabric interconnect
• B.Layer 1 port of the opposite fabric interconnect
• C.Layer 2 port of the same fabric interconnect
• D.out-of-band management network