Question 126
Refer to the exhibit.
Which password must an engineer use to enter the enable mode?
Which password must an engineer use to enter the enable mode?
Question 127
R1 has learned route 192.168.12.0/24 via IS-IS. OSPF, RIP. and Internal EIGRP Under normal operating conditions, which routing protocol is installed in the routing table?
Question 128
Where does the configuration reside when a helper address Is configured lo support DHCP?
Question 129
Refer to the exhibit.
What does router R1 use as its OSPF router-ID?
What does router R1 use as its OSPF router-ID?
Question 130
What will be the result if the following configuration commands are implemented on a Cisco switch?
Switch (config-if)# switchport port-security
Switch (config-if)# switchport port-security mac-address sticky
Switch (config-if)# switchport port-security
Switch (config-if)# switchport port-security mac-address sticky