A.lldp timer

B.lldp holdtimt

C.lldp reinit

D.lldp tlv-select

A.The interface is not participating in OSPF

B.A point-to-point network type is configured

C.The default Hello and Dead timers are in use

D.There are six OSPF neighbors on this interface

A.access-list 100 deny tcp host 172.16.1.33 any eq 22 access-list 100 permit ip any any interface GigabitEthernet0/0 ip access-group 100 in

B.access-list 100 deny tcp host 172.16.1.33 any eq 22 access-list 100 permit ip any any line vty 0 15 ip access-group 100 in

C.access-list 100 deny tcp host 172.16.1.33 any eq 23 access-list 100 permit ip any any interface GigabitEthernet0/0 ip access-group 100 in

D.access-list 100 deny tcp host 172.16.1.33 any eq 23 access-list 100 permit ip any any line vty 0 15 ip access-group 100 in

A.It requires only one IP address per VLAN.

B.It requires only three IP addresses per VLAN.

C.It supports redundant configuration files.

D.It reduces management overhead.

E.It supports HSRP, VRRP, and GLBP.

F.Switches can be located anywhere regardless of their physical distance from one anot her.

A.It multiples the active K values by 256 to calculate the route with the lowest metric.

B.It counts the number of hops between the source router and the destination to determine the route with the lowest metric.

C.It divides a reference bandwidth of 100 Mbps by the actual bandwidth of the exiting interface to calculate the route with the lowest cost.

D.For each existing interface, it adds the metric from the source router to the destination to calculate the route with the lowest bandwidth.