Question 426
Which command should you enter to configure a single port to prevent alternate ports from becoming designated ports?
Question 427
Refer to the exhibit.
An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?
An engineer booted a new switch and applied this configuration via the console port. Which additional configuration must be applied to allow administrators to authenticate directly to enable privilege mode via Telnet using a local username and password?
Question 428
Which NTP command configures the local devices as an NTP reference clock source?
Question 429
Refer to the exhibit.
A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?
A packet is being sent across router R1 to host 172.163.3.14. To which destination does the router send the packet?
Question 430
Refer to the exhibit.
Which route type does the routing protocol Code D represent in the output?
Which route type does the routing protocol Code D represent in the output?