Lab Simulation 2
Physical connectivity is implemented between the two Layer 2 switches, and the network connectivity between them must be configured:
1. Configure an LACP EtherChannel and number it as 1; configure it between switches SW1 and SVV2 using interfaces Ethernet0/0 and Ethernet0/1 on both sides. The LACP mode must match on both ends.
2 Configure the EtherChannel as a trunk link.
3. Configure the trunk link with 802.1 q tags.
4. Configure the native VLAN of the EtherChannel as VLAN 15.

Drag and drop the characteristics of network architectures from the left onto the type of architecture on the right.

Refer to the exhibit.

Which configuration on RTR-1 denies SSH access from PC-1 to any RTR-1 interface and allows all other traffic?

Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right

Which two command sequences must you configure on a switch to establish a Layer 3 EtherChannel with an open-standard protocol? (choose two)