Free Access Cisco.200-301.v2026-09-23.q650 Practice Test (Page 123)

Question 606

Which command is used to specify the delay time in seconds for LLDP to initialize on any interface?

A.lldp timer

B.lldp holdtimt

C.lldp reinit

D.lldp tlv-select

Question 607

When a floating static route is configured, which action ensures that the backup route is used when the primary route fails?

A.The floating static route must have a higher administrative distance than the primary route so it is used as a backup

B.The default-information originate command must be configured for the route to be installed into the routing table

C.The floating static route must have a lower administrative distance than the primary route so it is used as a backup

D.The administrative distance must be higher on the primary route so that the backup route becomes secondary.

Question 608

Refer to the exhibit.

All interfaces are in the same VLAN. All switches are configured with the default STP priorities. During the STP electronics, which switch becomes the root bridge?

A.MDF-DC-08:0E:18:22:05:97

B.MDF-DC-1:DB:E:44:02:54:79

C.MDF-DC-4:08:E0:19: 08:B3:19

D.MDF-DC-3:08:0E:18::1A:3C:9D

Question 609

Drag and drop the IPv4 network subnets from the left onto the correct usable host ranges on the right

Question 610

Refer to the exhibit. A network engineer must update the configuration on Switch2 so that it sends LLDP packets every minute and the information sent via LLDP is refreshed every 3 minutes.
Which configuration must the engineer apply?