A First Hop Redundancy Protocol protects the default gateway function for hosts on a subnet. Without FHRP, a host typically points to one router interface as its default gateway. If that router or interface fails, the host loses off-subnet connectivity even if another router is available. FHRP solves that by allowing multiple routers to present a single virtual gateway to the LAN. Depending on the protocol, routers elect active and standby roles or share forwarding. Cisco technologies in this space include HSRP, while VRRP is standards- based and GLBP adds gateway load-balancing behavior. The exam answer is not about sharing configuration data, bridge priorities, or OSPF equal-cost routing. Those are separate functions. Cisco CCNA 200-301 v1.1 tests FHRP under IP Connectivity because a working default gateway is essential to end-to-end routing. The primary purpose is to reduce routing failures by allowing more than one router to represent itself as the default gateway for a network.

See the Explanation below.
Explanation:
Answer as below configuration:
1.- on R3
config terminal
ip route 192.168.1.1 255.255.255.255 209.165.200.229
end
copy running start
2.- on R2
config terminal
ip route 0.0.0.0 0.0.0.0 209.165.202.130
end
copy running start
3.- on R2
config terminal
ipv6 route ::/0 2001:db8:abcd::2
end
copy running start

Auto summary uses "classful boundary"
- 10.4.3.0 with mask 255.0.0.0 gives 10.0.0.0
- 172.16.4.0 with mask 255.255.0.0 gives 172.16.0.0
- 192.168.2.0 with mask 255.255.255.0 gives 192.168.2.0

Explanation
We can see in this picture we have to type 64 hexadecimal characters (256 bit) for the WPA2 passphrase so we can deduce the encryption is AES-256, not AES-128.

https://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/67134-wpa2-config.html