Question 36
Refer to the exhibit.
Which prefix did router R1 learn from internal EIGRP?
Which prefix did router R1 learn from internal EIGRP?
Question 37
Drag and drop the TCP/IP protocols from the left onto the transmission protocols on the right
Question 38
Refer to the exhibit.
An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.
An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.
Question 39
Drag and drop the attack-mitigation techniques from the left onto the Types of attack that they mitigate on the right.
Question 40
Lab Simulation 59
Please use the "Tasks" and "Topology" tabs to complete this lablet.
Topology
Tasks
Refer to the topology. All physical cabling is in place, and a routing protocol is preconfigured on all network devices.
Task 1:
Using the minimum number of ACEs, configure an extended named ACL and place it within the topology to conserve as many resources as possible. ACL requirements are:
- ACL name = WEB_ACL
- Allow HTTP traffic only from VLAN 200
- Block telnet only for PC1
- Allow all other traffic
Task 2:
Configure a local account on Sw2 with telnet access only on virtual ports 0-4. Use the following information:
- Username: GroupAdmin
- Password: BumbL3
- Algorithm type: Scrypt
- Privilege level: Exec mode
Task 3:
Configure Sw3:
- Enable DHCP snooping for VLANs 100 and 200
- Enable DHCP snooping MAC address verification
Please use the "Tasks" and "Topology" tabs to complete this lablet.
Topology
Tasks
Refer to the topology. All physical cabling is in place, and a routing protocol is preconfigured on all network devices.
Task 1:
Using the minimum number of ACEs, configure an extended named ACL and place it within the topology to conserve as many resources as possible. ACL requirements are:
- ACL name = WEB_ACL
- Allow HTTP traffic only from VLAN 200
- Block telnet only for PC1
- Allow all other traffic
Task 2:
Configure a local account on Sw2 with telnet access only on virtual ports 0-4. Use the following information:
- Username: GroupAdmin
- Password: BumbL3
- Algorithm type: Scrypt
- Privilege level: Exec mode
Task 3:
Configure Sw3:
- Enable DHCP snooping for VLANs 100 and 200
- Enable DHCP snooping MAC address verification