Online Access Free 201 Practice Test

Which two methods can be used to determine which BIG-IP is currently active? (Choose two.)

• A.The status (Active/Standby) is embedded in the command prompt.
• B.Only the active system's configuration screens are active.
• C.The bigtop command displays the status.
• D.The ifconfig a command displays the floating addresses on the active system.

What is the purpose of MAC masquerading?

• A.to allow both BIGIP devices to simultaneously use the same MAC address
• B.to prevent ARP cache errors
• C.to minimize ARP entries on routers
• D.to minimize connection loss due to ARP cache refresh delays

Refer to the exhibit. The BIG-IP Administrator needs to avoid overloading any of the Pool Members with connections, when they become active.
What should the BIG-IP Administrator configure to meet this requirement?

• A.Slow Ramp Time to the Pool
• B.Same Priority Group to each member
• C.Different Ratio for each member
• D.Action On Service Down to Reselect

Refer to the exhibit.


A BIG-IP Administrator creates a new Virtual Server to load balance SSH traffic. Users are unable to log on to the servers.
What should the BIG-IP Administrator do to resolve the issue?

• A.Set HTTP Profile to None
• B.Set Destination Addresses/Mask to 0.0.0.0/0
• C.Set Protocol to UDP
• D.Set Source Address to 10.1.1.2

Which two statements are true about NATs? (Choose two.)

• A.NATs support UDP, TCP, and ICMP traffic.
• B.NATs provide a one-to-one mapping between IP addresses.
• C.NATs provide a many-to-one mapping between IP addresses.
• D.NATs can be configured with mirroring enabled or disabled.