Online Access Free 220-1001 Practice Test

An end user reports a printer error that states "Replace filament". With which of the following types of printer is the end user MOST likely having problems?

• A.ink jet
• B.3-D
• C.Thermal
• D.Laser

A Windows user wants a specific USB flash drive to always appear as the same drive letter. Which of the following would help accomplish this goal?

• A.MSConfig
• B.System Configuration
• C.Local Security Policy
• D.Disk Management

A technician is installing a pair of 7.2K rpm hard drives into a NAS unit. Which of the following will provide the HIGHEST levels of performance for the setup?

• A.RAID 10
• B.RAID 5
• C.RAID 0
• D.RAID 1

Megan, the CEO, is unable to connect to the company's network on her company-issued enterprise tablet when in the office, however, it works perfectly from home. All the corporate laptops are connected to the wireless network without issue. She has asked you for assistance in getting the device online.
INSTRUCTIONS
Review the network diagrams and device configurations to determine the cause of the problem and resolve any discovered issues.
If at any time you would like to bring back the initial state of the simulation, please click the Reset All button.

Correct Answer:

Click on Tablet Office 3

Click on 802.11 and Select a

Click on SSID and select CORP

At Wireless Security Mode, Click on Security Mode

Select the WPA2

Megan needs to connect to the CORP SSID, using 2.4GHZ. The selected security method chose should be WPA2, and the password should be set to Corpsecure1.

A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor. The technician sees both a flashing green LED and a flashing orange LED on the workstation's NIC.
Which of the following should the technician do FIRST?

• A.Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
• B.Run continuity tests using an Ethernet cable tester to determine if any pairs are broken.
• C.Check the RJ45 end connectors, the jacks, and the ends of the run of the Cat 5 UTP cable for loose connections, pinched bends, and visible damage.
• D.Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.