Online Access Free 300-115 Practice Test

After you connected a host to switch port GO/1, the port error disabled. Which command can you enter to determine the reason?

• A.show ip interface brief
• B.Show run interface g0/1
• C.show interfaces g0/1 status
• D.show log

Which two statements about HSRP, GLBP, and VRRP are true? (Choose two.)

• A.VRRP has one master router, one standby router, and many listening routers.
• B.HSRP is the preferred protocol to be used on multivendor environments.
• C.HSRP supports up to 255 groups on the same switch or router.
• D.VRRP is a Cisco proprietary protocol.
• E.GLBP allows for a maximum of four MAC addresses per group.

In which circumstances does a port security violation occur? (Choose two.)

• A.when sticky MAC address learning is enabled and the port has a link-down condition
• B.when a port with a secure MAC address attempts to use a different port in the same VLAN
• C.when the port has received more MAC addresses than allowed
• D.when the same MAC address enters a port more than once
• E.when the CAN table overflows with dynamically learned MAC addresses

Which two statements about native VLANs are true? (Choose two)

• A.Cisco Discovery Protocol versions 1 and 2 can carry native VLAN information.
• B.The native VLAN is untagged over trunks
• C.VLAN 1 and VLAN 1001 are native VLANs by default
• D.Only one VLAN can be the native VLAN on a device.
• E.The native VLAN can be changed on a per-port basis

Which two commands can you enter to configure load-balancing at Layer 2? (choose two.)

• A.port-channel load-balance dst-ip
• B.port-channel load-balance src-mac
• C.port-channel load-balncing src-dest-mac
• D.port-channel load-balancing src-dst-ip
• E.port-channel load-balance src-ip