Online Access Free 300-135 Practice Test

Which two of the following options are categories of Network Maintenance tasks?

• A.Foundational
• B.Policy-based
• C.Interrupt-driven
• D.Firefighting
• E.Structured

Which of the following commands will restore a previously archived configuration by replacing the running configuration with the archived configuration?

• A.copy startup-config running-config
• B.configure archive running-config
• C.configure tftp running-config
• D.copy tftp running-config
• E.copy archive running config
• F.configure replace

Scenario:
A customer network engineer has edited their OSPF network configuration and now your customer is experiencing network issues. They have contacted you to resolve the issues and return the network to full functionality.







The OSPF neighbour relationship has been lost between R1 and R3. What is causing this problem?

• A.A neighbor statement needs to be configured in R1 and R3 pointing at each other.
• B.The R1 network type should be changed to point-to-multipoint non-broadcast.
• C.The hello, dead and wait timers on R1 need to be reconfigured to match the values on R3.
• D.The serial interface in R1 should be taken out of the shutdown state.

What should be the next step after the problem is solved?

• A.document it
• B.result analysis
• C.knowledge transfer

The implementation group has been using the test bed to do an IPv6 'proof-of-concept1. After several changes to the network addressing and routing schemes, a trouble ticket has been opened indicating that the loopback address on R1 (2026::111:1) is not able to ping the loopback address on DSW2 (2026::102:1).
Use the supported commands to isolate the cause of this fault and answer the following question.
What is the solution to the fault condition?

• A.Under ipv6 router ospf 6 configuration enter the redistribute rip RIP_ZONE include-connected command.
• B.Under the interface Loopback6 configuration enter the ipv6 ospf 6 area 34 command.
• C.Under the interface Serial0/0/0.34 configuration enter the ipv6 ospf 6 area 34 command.
• D.Under the interface Tunnel34 configuration enter the ipv6 ospf 6 area 34 command.