Online Access Free 300-365 Practice Test

Which CLI command does a wireless engineer use to display the maximum number of hops?

• A.show mesh statistics
• B.show ap config general
• C.show mesh config
• D.show mesh hop-count

An engineer has enabled Cisco Centralized Key Management on a WLAN with local and FlexConnect mode APs. The engineer notices that Cisco CKM is not working for theFlexConnect APs when looking at roaming, but is working for local mode APs. Which change is needed on the controller for Cisco CKM to work for the FlexConnect APs?

• A.Use local authentication.
• B.Enable FlexConnect Central Assoc.
• C.Place APs in FlexConnect group.
• D.Configure VLAN-based central switching.

A WLAN engineer has been asked to upgrade the software on a MSE 3365 Appliance. The engineer cannot access the system using the root password and the Grub password as the details had never been documented.
How should the engineer perform the password recovery?

• A.Boot the MSE using the software installation DVD.
• B.Use a console cable.
• C.The Password can be reset using Prime Infrastructure.
• D.Contact Cisco TAC and arrange an RMA of the MSE.

A FlexConnect remote office deployment is using five 2702i APs indoors and two 1532i APs outdoors. When a code upgrade is performed and FlexConnect Smart AP Image Upgrade is leveraged, but no FlexConnect Master AP has been configured. How many image transfers between the WLC and APs will occur?

• A.1
• B.5
• C.7
• D.2

An engineer has enabled FlexConnect AP Upgrade for a FlexConnect group, but did not manually select any master APs. Which AP receives the update directly from the controller when a FlexConnect Upgrade is initiated?

• A.one AP with the lowest MAC address in the group
• B.one AP with the lowest MAC address in each subnet in the group
• C.one AP of each model with the lowest MAC address in the group
• D.one AP with the highest MACaddress in the group