Question 116
An engineer is creating a policy that overrides normal routing behavior.if the route to a destination of
10.100.100.0/24 is withdrawn from the routing
Table, the policy must direct traffic to a next hop of 10.1 1.1. if the route is present in the routing table, then normal forwarding must occur. Which configuration meets the requirements?
10.100.100.0/24 is withdrawn from the routing
Table, the policy must direct traffic to a next hop of 10.1 1.1. if the route is present in the routing table, then normal forwarding must occur. Which configuration meets the requirements?
Question 117
Refer to the exhibit.
Refer to the exhibit. An engineer configured route exchange between two different companies for a migration project EIGRP routes were learned in router C but no OSPF routes were learned in router A.
Which configuration allows router A to receive OSPF routes?
Refer to the exhibit. An engineer configured route exchange between two different companies for a migration project EIGRP routes were learned in router C but no OSPF routes were learned in router A.
Which configuration allows router A to receive OSPF routes?
Question 118
What is the minimum time gap required by the local system before putting a BFD control packet on the wire?
Question 119
An engineer configured a company's multiple area OSPF head office router and Site A cisco routers with VRF lite. Each site router is connected to a PE router of an MPLS backbone.
After finishing both site router configurations, none of the LSA 3,4 5, and 7 are installed at Site A router. Which configuration resolves this issue?
After finishing both site router configurations, none of the LSA 3,4 5, and 7 are installed at Site A router. Which configuration resolves this issue?
Question 120
Refer to the exhibit.
Refer to me exhibit. The hub and spoke are connected via two DMVPN tunnel interfaces The NHRP is configured and the tunnels are detected on the hub and the spoke Which configuration command adds an IPsec profile on both tunnel interfaces to encrypt traffic?
Refer to me exhibit. The hub and spoke are connected via two DMVPN tunnel interfaces The NHRP is configured and the tunnels are detected on the hub and the spoke Which configuration command adds an IPsec profile on both tunnel interfaces to encrypt traffic?
Premium Bundle
Newest 300-410 Exam PDF Dumps shared by BraindumpsPass.com for Helping Passing 300-410 Exam! BraindumpsPass.com now offer the updated 300-410 exam dumps, the BraindumpsPass.com 300-410 exam questions have been updated and answers have been corrected get the latest BraindumpsPass.com 300-410 pdf dumps with Exam Engine here: