Which OSPF command makes the WAN Edge router a less preferred exit from a site with a dual WAN Edge design?
A)

B)

C)

D)

Refer to the exhibit. The SD-WAN network is configured with a default full-mesh topology. The network engineer wants the Rome WAN Edge to use the MPLS TLOC as the preferred TLOC when forwarding Telnet traffic as long as the MPLS link has these characteristics:
Loss: 5%
Latency: 100ms
Jitter: 100 ms
Which configuration must the network engineer use to create a list that that classifies the MPLS link characteristics?

What are the two reasons a customer chooses to use IPsec tunnels over GRE? (Choose two.)

Refer to the exhibit. Customer XYZ cannot provision dual connectivity on both of its routers due to budget constraints but wants to use both R1 and R2 interlaces for users behind them for load balancing toward the hub site.
Which configuration achieves this objective?

The Cisco SD-WAN engineer is configuring service chaining for a next-generation firewall located at the headquarters. Which configuration creates the service?