Question 81
Which command set configures a Cisco Catalyst 9800 Series Wireless Controller so that the client traffic enters the network at the AP switch port?
Question 82
An engineer needs to provision certificates on a Cisco Catalyst 9800 Series Wireless Controller. The customer uses a third-party CA server. Which protocol must be used between the controller and CA server to request and install certificates?
Question 83
An engineer is implementing RADIUS to restrict administrative control to the network with the WLC management IP address of 192.168.1.10 and an AP subnet of 192.168.2.0/24. Which entry does the engineer define in the RADIUS server?
Question 84
Refer to the exhibit.
An engineer must connect a fork lift via a WGB to a wireless network and must authenticate the WGB certificate against the RADIUS server. Which three steps are required for this configuration? (Choose three.)
An engineer must connect a fork lift via a WGB to a wireless network and must authenticate the WGB certificate against the RADIUS server. Which three steps are required for this configuration? (Choose three.)
Question 85
Refer to the exhibit An ACL is configured to restrict access for BYOD clients.
The ACL must redirect devices to the guest portal. To which two devices on the local network must the ACL allow access other than the DHCP server?
(Choose two.)
The ACL must redirect devices to the guest portal. To which two devices on the local network must the ACL allow access other than the DHCP server?
(Choose two.)