Free Access Cisco.300-510.v2025-06-23.q161 Practice Test (Page 3)

Question 6

Refer to the exhibit. R3 is:
* failing to accept multicast RP information from Domain-A
* advertising MSDP SA messages to R1 and R4
* receiving SA messages only from R4
Which command must the engineer implement to resolve the issue?

A.R3# ip msdp sa-filter in 192.168.3.1

B.R3# no ip msap sa-filter in 192.168.1.1

C.R3# no ip msdp peer 192.168.1.1

D.R3# ip msdp sa-filter out 192.168.1.1

Question 7

Drag and drop the features about multicast from the left onto the multicast protocols on the right. Not all options ate used.

Question 8

Refer to the exhibit.

Refer to the exhibit After recent configuration changes to a customer's network, a network engineer notices that R2 cannot communicate with R3 Both FastEthemet interfaces on R2 and R3 are up and configured with the correct IP addresses MD5 password configured en R2 and R3 match with no issues What is the minimum change the engineer must make to enable R2 and R3 to communicate and fix the problem?

A.Configure a loopback interface on R2 and assign it to area 0.

B.Define area 2 as a NSSA on R2 and R3

C.Configure virtual links between RI and R3.

D.Configure interface F0/0 on RI and R2 to be in area O.

Question 9

Refer to the exhibit.

What is the effect of this configuration?

A.It sets the hold timer to 30 milliseconds and the keepalive timer to 240 milliseconds.

B.It sets the keepalive timer to 30 milliseconds and the hold timer to 240 milliseconds.

C.It sets the keepalive timer to 30 seconds and the hold timer to 240 seconds.

D.It sets the hold timer to 30 seconds and the keepalive timer to 240 seconds.

Question 10

Refer to the exhibit Router 1 resides in a different data center than Rouler 2 and Router 3. Router 1 is running the IS-IS routing protocol, and it is preconfigured with LDP and segment routing Which configuration must the engineer apply under router isis 111 on Router 1 to implement Tl-LFA on the link to Router 2 without disrupting traffic to Router 3?