Free Access Cisco.300-515.v2022-06-14.q64 Practice Test (Page 4)

Question 11

An ISP provides a major client MPLS VPN for managed services. The MPLS engineering team needs to use the advanced VPN feature of selective VRF import so that only specific prefixes are present in the required VPNs.
Which aspect of this feature must the team consider?

A.A route must pass the import route map first and then the route target import filter.

B.The routers that are imported in the VRF can be BGP and IGP routes, so other match conditions in the route map, besides communities, can be used.

C.The import-map command is applied under the PE interface that connects to the CE router.

D.A route is imported into the VRF only when at least one RT that is attached to the route matches one RT that is configured in the VRF and the route is permitted by the import route map.

Question 12

Refer to the exhibit.

What is the effect of this configuration?

A.Router 1 accepts multicast routes with a tag of 12:1

B.A Cisco MPLS TE tunnel is generated with 192.168.1.2 as the source IP address of router 1.

C.An LSP virtual interface tunnel is created.

D.The mroute table is cleared.

Question 13

Which statement describes the no bgp default route-target filter

A.Prefixes that are received with route targets and distinguisher are accepted.

B.Prefixes that are received with route targets and distinguisher are not accepted.

C.Prefixes that are received with route targets that are not imported at the PE are accepted.

D.Prefixes that are received with route targets that are not imported at the PE are not accepted.

Question 14

Refer to the exhibit.

What is shown in this output?

A.BGP is used between neighbors that are exchanging MPLS labels

B.the labels received and advertised on PE1

C.LDP neighbor statuses

D.local and outgoing abels are updated in hardware

Question 15

Refer to the exhibit:

A network engineer is implementing an OSPF configuration Based on the output, which statement is true?

A.OSPFv3 cannot be configured for IPv4; OSPFv3 works only for IPv6.

B.IPv6 routing not enabled" is just an informational message and OSPFv3 runs for IPv4 on interface FastEthernet0/0 anyway

C.In the ospfv3 1 area 1 ipv4 command, area 0 must be configured instead of area 1.

D.OSPFv3 does not run for IPv4 on FastEthemet0/0 until IPv6 routing is enabled on the router and IPv6 is enabled on interface Fastfc.thernet0/0

Other Version: 1171Cisco.300-515.v2024-02-07.q87; 2100Cisco.300-515.v2022-02-12.q63

Latest Upload: 241EC-COUNCIL.312-38.v2026-10-22.q321; 125WGU.Health-Fitness-and-Wellness.v2026-10-21.q14; 163ISACA.COBIT-Design-and-Implementation.v2026-10-21.q57; 159NACE.NACE-CIP2-001.v2026-10-21.q36; 213Cisco.400-007.v2026-10-21.q176; 181F5.301a.v2026-10-21.q97; 164Oracle.1z0-1195-26.v2026-10-19.q18; 159Salesforce.Salesforce-Slack-Administrator.v2026-10-19.q126; 211Salesforce.JS-Dev-101.v2026-10-19.q106; 274PaloAltoNetworks.SSE-Engineer.v2026-10-17.q44

Question 11

Question 12

Question 13

Question 14

Question 15

Download PDF File