Free Access Cisco.300-615.v2022-05-03.q107 Practice Test (Page 20)

Question 91

Drag and drop the commands from the left onto the correct categories on the right.

Question 92

An engineer must replace a failed memory on a Cisco UCS B-Series Blade Server. After the replacement was done, the server has a "resolve slot" warning. Which server maintenance action resolves the issue?

A.Perform diagnostic interrupt on the server.

B.Decomission the server.

C.Reset the server.

D.Re-acknowlegement the server.

Question 93

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

Question 94

Refer to the exhibit.

During implementation of a Cisco UCS C-Series Server, an engineer receives the status that is shown in the exhibit. Which action resolves the issue.

A.Reconfigure the Drive Type from "Removable" to "Non-Removable"

B.Set SLOT-1 Sync Mode to "Auto"

C.Insert an SD card into SLOT-2

D.Configure the RAID that is associated with the card.

Question 95

A user reports that they cannot reach from a UCS server to an FC Storage array. Which command is used to test communication between an FCF and a target?

A.fcroute

B.traceroute

C.fcping

D.ping

Other Version: 807Cisco.300-615.v2024-09-25.q117; 1034Cisco.300-615.v2023-01-31.q58; 2599Cisco.300-615.v2022-10-01.q126; 2685Cisco.300-615.v2022-05-28.q107; 93Cisco.Exams4sures.300-615.v2021-11-23.by.tess.99q.pdf

Latest Upload: 202PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 299Nokia.4A0-113.v2026-05-01.q69; 258EC-COUNCIL.312-49v11.v2026-04-30.q214; 228Microsoft.MB-820.v2026-04-30.q101; 211Salesforce.MC-202.v2026-04-30.q57; 206BICSI.INSTC_V8.v2026-04-29.q53; 335NMLS.MLO.v2026-04-28.q82; 243NCARB.Project-Management.v2026-04-28.q27; 465EMC.D-AV-DY-23.v2026-04-27.q184; 1120ServiceNow.CSA.v2026-04-27.q483

Question 91

Question 92

Question 93

Question 94

Question 95

Download PDF File