Free Access Cisco.300-615.v2024-09-25.q117 Practice Test (Page 16)

Question 71

Refer to the exhibit.

A recent configuration change removes the HSRP adjacency between the SW-1 and SW-2 Cisco Nexus switches. The change causes the servers on this subnet to lose Internet access. Which action restores the connectivity of all servers on VLAN 13?

A.Set the HSRP password on SW-2.

B.Disable HSRP IP redirects on SW-1.

C.Activate HSRP preempt on SW-2.

D.Set the HSRP priority to 70 on SW-1.

Question 72

Drag each item listed on the left to its proper category on the right Not all items will fit the categories.

Question 73

Refer to an exhibit.

An engineer is troubleshooting an upgrade failure on a switch. Which action resolves the issue?

A.Load a new system image.

B.Reload the same system image.

C.Use the same system image as the kickstart image.

D.Save the system image in NVRAM.

Question 74

Refer to the exhibit.

A client reports that the routing protocol neighborship fails to start between two Cisco Nexus switches, N9K-1 and N9K-2. Which action resolves the issue?

A.Add MTU configuration to interface e1/1 on both Cisco Nexus switches

B.Configure a multicast access list to allow the negotiation between N9K-1 and N9K-2

C.Configure a unicast access list to allow the negotiation between N9K-1 and N9K-2

D.Add OSPF routing configuration to interface e1/1 on both Cisco Nexus switches

Question 75

A customer reports that the Chassis Management Controller fails to receive chassis information from Cisco UCS Manager. Which set of steps resolves the issue?

A.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

B.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status
4) Reseat the affected IOM.

C.1) Verify that the IOM firmware and Cisco UCS Manager are at the same software level.
2) Verify that at least two physical cables between the IOM and fabric interconnect function properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

D.1) Verify that the IOM firmware and Cisco UCS Manager are at different software levels.
2) Verify that at least one physical cable between the IOM and fabric interconnect functions properly.
3) Check for runtime link down status.
4) Reseat the affected IOM.

Other Version: 1034Cisco.300-615.v2023-01-31.q58; 2598Cisco.300-615.v2022-10-01.q126; 2684Cisco.300-615.v2022-05-28.q107; 2733Cisco.300-615.v2022-05-03.q107; 93Cisco.Exams4sures.300-615.v2021-11-23.by.tess.99q.pdf

Latest Upload: 202PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 299Nokia.4A0-113.v2026-05-01.q69; 255EC-COUNCIL.312-49v11.v2026-04-30.q214; 228Microsoft.MB-820.v2026-04-30.q101; 211Salesforce.MC-202.v2026-04-30.q57; 206BICSI.INSTC_V8.v2026-04-29.q53; 335NMLS.MLO.v2026-04-28.q82; 243NCARB.Project-Management.v2026-04-28.q27; 463EMC.D-AV-DY-23.v2026-04-27.q184; 1117ServiceNow.CSA.v2026-04-27.q483

Question 71

Question 72

Question 73

Question 74

Question 75

Download PDF File