Which command-line mode is supported from the Cisco FMC CLI?

A company wants a solution to aggregate the capacity of two Cisco FTD devices to make the best use of resources such as bandwidth and connections per second. Which order of steps must be taken across the Cisco FTDs with Cisco FMC to meet this requirement?

What is the result of specifying of QoS rule that has a rate limit that is greater than the maximum throughput of an interface?

An engineer is troubleshooting a device that cannot connect to a web server. The connection is initiated from the Cisco FTD inside interface and attempting to reach 10.0.1.100 over the non-standard port of 9443 The host the engineer is attempting the connection from is at the IP address of 10.20.10.20. In order to determine what is happening to the packets on the network, the engineer decides to use the FTD packet capture tool Which capture configuration should be used to gather the information needed to troubleshoot this issue?
A)

B)

C)

D)

Refer to the exhibit.

An organization has an access control rule with the intention of sending all social media traffic for inspection After using the rule for some time, the administrator notices that the traffic is not being inspected, but is being automatically allowed What must be done to address this issue?