Free Access Cisco.300-710.v2022-07-27.q166 Practice Test (Page 14)

Question 61

How many report templates does the Cisco Firepower Management Center support?

A.20

B.unlimited

C.10

D.5

Question 62

An engineer is investigating connectivity problems on Cisco Firepower that is using service group tags. Specific devices are not being tagged correctly, which is preventing clients from using the proper policies when going through the firewall How is this issue resolved?

A.Use Wireshark with an IP subnet filter.

B.Use traceroute with advanced options.

C.Use a packet sniffer with correct filtering

D.Use a packet capture with match criteria.

Question 63

An engineer configures an access control rule that deploys file policy configurations to security zones, and it cause the device to restart. What is the reason for the restart?

A.Source or destination security zones in the access control rule matches the security zones that are associated with interfaces on the target devices.

B.The source tunnel zone in the rule does not match a tunnel zone that is assigned to a tunnel rule in the source policy.

C.The source tunnel zone in the rule does not match a tunnel zone that is assigned to a tunnel rule in the destination policy.

D.Source or destination security zones in the source tunnel zone do not match the security zones that are associated with interfaces on the target devices.

Question 64

Which Cisco Firepower Threat Defense, which two interface settings are required when configuring a routed interface? (Choose two.)

A.Redundant Interface

B.EtherChannel

C.Speed

D.Media Type

E.Duplex

Question 65

An engineer is troubleshooting a device that cannot connect to a web server. The connection is initiated from the Cisco FTD inside interface and attempting to reach 10.0.1.100 over the non-standard port of 9443 The host the engineer is attempting the connection from is at the IP address of 10.20.10.20. In order to determine what is happening to the packets on the network, the engineer decides to use the FTD packet capture tool Which capture configuration should be used to gather the information needed to troubleshoot this issue?
A)