The Analysis > Hosts > Vulnerabilities page in Cisco FMC displays information about the hosts on the network and their associated vulnerabilities. The administrator can filter the hosts by impact level, which indicates how likely an attack is to succeed against a host. An impact level of 2 means that the host was attacked and is potentially vulnerable, but no exploit was confirmed. The administrator can click on a host to view more details, such as its IP address, operating system, applications, protocols, and intrusion events. The administrator can also view the details of each vulnerability, such as its CVE ID, description, severity, and recommended actions3

To deploy a Cisco FTD device that meets the requirements of the question, the engineer must use transparent mode with a management interface. Transparent mode is a firewall configuration in which the FTD device acts as a "bump in the wire" or a "stealth firewall" and is not seen as a router hop to connected devices. In transparent mode, the FTD device can examine traffic without requiring network changes that will disrupt end users, such as changing IP addresses or routing configurations1. A management interface is a dedicated interface that is used for managing the FTD device and separating management traffic from data traffic. A management interface can be configured to allow SSH access for remote administration, which is more secure than Telnet2.
The other options are incorrect because:
* Routed mode is a firewall configuration in which the FTD device acts as a router and performs address translation and routing for connected networks. Routed mode requires network changes that may disrupt end users, such as changing IP addresses or routing configurations1. A diagnostic interface is a special interface that is used for troubleshooting and capturing traffic on the FTD device. A diagnostic interface does not separate management traffic from data traffic or allow SSH access for remote administration.
* Transparent mode with a data interface does not meet the requirement of separating management traffic from data traffic. A data interface is a regular interface that is used for passing and inspecting traffic on the FTD device. A data interface does not allow SSH access for remote administration2.
* Routed mode with a bridge virtual interface (BVI) does not meet the requirement of examining traffic without requiring network changes that will disrupt end users. A BVI is a logical interface that acts as a container for one or more physical or logical interfaces that belong to the same layer 2 broadcast domain. A BVI allows the FTD device to route between different bridge groups on the same security module/engine. However, routed mode still requires network changes that may disrupt end users, such as changing IP addresses or routing configurations.