Online Access Free 350-029 Practice Test

In PIM-SM operations, to which device does the first router that connects with the multicast source send the register message?

• A.multicast source
• B.RP
• C.IGMP router
• D.multicast receiver
• E.PIM designated router

You applied this ACL to the interface and several people reported that they were unable to access the network.
ipv6 access-list webOnly permit tcp any 2001:DB8::/32 permit udp any 2001:DB8::/32 deny ipv6 any any
Which answer explains why they were unable to access the network?

• A.DHCP requests are not reaching to the DHCP server.
• B.The ACL is blocking the operation of the ND process.
• C.DNS queries and replies are not working.
• D.The connections are stale. The users must close and restart their applications.

Which statement about multicast VPN is true?

• A.Configuration of the MDT source on a pre-VRF basis is supported only on IPv6.
• B.The MDT group address should be different for both address families in the same VRF.
• C.The MDT group address should be the same for both address families in the same VRF.
• D.The MDT group address should be the same for both address families in the different VRFs.

Which two statements about the bgp deterministic-med and bgp always-compare-med commands are true? (Choose two)

• A.The bgp deterministic-med and bgp always-compare-med commands are enabled by defult.
• B.The bgp deterministic-med command is used to influence the BGP route selection process to cause the MED attribute to have higher precedence over the AS path length
• C.Enabling the bgp always-compare-med command ensures the comparison of the MED variable for paths from neighbors in different autonomous systems.
• D.Enabling the bgp deterministic-med command ensures the comparison of the MED variable when choosing routes advertised by different peers in the same autonomous system.
• E.The bgp always-compare command is used to influence the BGP route selection process to cause the MED attribute to have higher precedence over the AS path system.

When should traffic shaping be implemented on Frame Relay PVCs? (Choose two)

• A.When you want to drop excess traffic above the CIR
• B.When LLQ is implemented on the Frame Relay PVC.
• C.When Multilink PPP LFI is implemented on the Frame Relay PVC.
• D.When over-subscribing the central site link
• E.When using Frame Relay SVCs
• F.When there is a speed mismatch between the central site and the remote site.