Online Access Free 350-050 Practice Test

What does disabling broadcast SSID in the WLAN configuration do?

• A.causes beacons to be unicast instead of broadcast
• B.forbids all broadcasts for that SSID
• C.makes the SSID respond only to blank probes
• D.allows beacons to be sent but leaves the SSID name field empty
• E.prevents beacons from being sent and allows only probes

During the installation of a Cisco WCS, you are given the option to modify the protocol ports used by the WCS. Which two of these protocol ports can you modify? (Choose two.)

• A.HTTPS
• B.FTP
• C.HTTP
• D.TFTP
• E.SNMP

When configuring management user authentication on a WLC, which statement is correct?

• A.You can configure users on the local WLC database with different authorization privileges for specific menus.
• B.A lobby ambassador user can push new management users to the WLC through Cisco WCS.
• C.You can configure an LDAP server to authenticate management users.
• D.If the local database is selected as a second priority after RADIUS, the local WLC database will not be used if the authentication fails through the RADIUS server.

Users complain about intermittent wireless connectivity issues. You see the following message on your Cisco WCS, corresponding the time the connectivity issues occurred.
AP 'building-1-entrance', interface '802.11b/g' on Controller '10.1.1.2'. Noise threshold violated.
What do you do?

• A.Increase the power of the APs in the entrance hall.
• B.Increase the interference threshold from the default 10%.
• C.Use a spectrum analyzer to discover the noise source.
• D.Check the logs for rogues in the area, and turn on rogue mitigation.

A wireless network administrator needs to limit guest user TCP traffic to no more than 50,000 kb/s, to conserve bandwidth on the guest WLAN. To do this, the administrator configures the average real-time rate to 50,000 kb/s and the burst real-time rate to 60,000 kb/s. Why does a test of the guest account show no restriction for the client TCP traffic?

• A.The administrator should have configured the average data rate and burst data rate.
• B.The average real-time rate and burst real-time rate should always be equal.
• C.The administrator should have configured the average data rate and the average real-time rate.
• D.The average real-time rate should always be higher than the burst real-time rate.