Question 81
Refer to the exhibit.
An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)
B)
C)
D)
An engineer must modify the access control list EGRESS to allow all IP traffic from subnet 10.1.10.0/24 to
10.1.2.0/24. The access control list is applied in the outbound direction on router interface GigabitEthemet 0/1.
Which configuration commands can the engineer use to allow this traffic without disrupting existing traffic flows?
A)
B)
C)
D)
Question 82
Drag and Drop the decryptions from the left onto the routing protocol they describe on the right.
Question 83
Refer to the exhibit.
An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change is required''
An engineer must create a configuration that executes the show run command and then terminates the session when user CCNP legs in. Which configuration change is required''
Question 84
An engineer must create an EEM script to enable OSPF debugging in the event the OSPF neighborship goes down. Which script must the engineer apply?
Question 85
Refer to the exhibit. A network engineer configures a GRE tunnel and enters the show Interface tunnel command. What does the output confirm about the configuration?