Question 211
What are two considerations when using SSO as a network redundancy feature? (Choose two)
Question 212
Simulation 02
Configure HSRP between DISTRO-SW1 and DISTRO-SW2 on VLAN 100 for hosts connected to ACCESS-SW1 to achieve these goals:
1. Configure group number 1 using the virtual IP address of 192.168.1.1/24.
2. Configure DlSTRO-SW1 as the active router using a priority value of 110 and DISTRO-SW2 as the standby router.
3. Ensure that DISTRO-SW2 will take over the active role when DISTRO-SW1 goes down, and when DISTRO-SW1 recovers, it automatically resumes the active role.
DISTRO-SW2
Configure HSRP between DISTRO-SW1 and DISTRO-SW2 on VLAN 100 for hosts connected to ACCESS-SW1 to achieve these goals:
1. Configure group number 1 using the virtual IP address of 192.168.1.1/24.
2. Configure DlSTRO-SW1 as the active router using a priority value of 110 and DISTRO-SW2 as the standby router.
3. Ensure that DISTRO-SW2 will take over the active role when DISTRO-SW1 goes down, and when DISTRO-SW1 recovers, it automatically resumes the active role.
DISTRO-SW2
Question 213
Reter to the exhibit.
An engineer configures the trunk and proceeds to configure an ESPAN session to monitor VLANs10. 20. and 30. Which command must be added to complete this configuration?
An engineer configures the trunk and proceeds to configure an ESPAN session to monitor VLANs10. 20. and 30. Which command must be added to complete this configuration?
Question 214
Refer to the exhibit.
Refer to the exhibit. A network administrator must configure router B to allow traffic only from network 10.1002.0 to networks outside of router 0. Which configuration must be applied?
A)
B)
C)
D)
Refer to the exhibit. A network administrator must configure router B to allow traffic only from network 10.1002.0 to networks outside of router 0. Which configuration must be applied?
A)
B)
C)
D)
Question 215
Refer to the exhibit.
An engineer implemented several configuration changes and receives the logging message on switch1. Which action should the engineer take to resolve this issue?
An engineer implemented several configuration changes and receives the logging message on switch1. Which action should the engineer take to resolve this issue?