Explanation
Customer needs are fast evolving. Typically, a network center is a heterogenous mix of various devices at multiple layers of the network. Bulk and automatic configurations need to be accomplished. CLI scraping is not flexible and optimal. Re-writing scripts many times, even for small configuration changes is cumbersome.
Bulk configuration changes through CLIs are error-prone and may cause system issues. The solution lies in using data models-a programmatic and standards-based way of writing configurations to any network device, replacing the process of manual configuration. Data models are written in a standard, industry-defined language. Although configurations using CLIs are easier (more human-friendly), automating the configuration using data models results in scalability.
Reference:
https://www.cisco.com/c/en/us/td/docs/optical/ncs1000/60x/b_Datamodels_cg_ncs1000/b_Datamodels_cg_ncs1

https://www.cisco.com/c/dam/en/us/products/collateral/security/amp-for-endpoints/c11-742008-00-cisco-amp-fo

See the solution below in Explanation:
Explanation:
Solution:
R22
int tun0
vrf forwarding FINANCE
ip add 10.10.10.2 255.255.255.0
tunn source e0/0
tunnel dest 209.165.200.230
no shut
ip route vrf FINANCE 10.10.111.0 255.255.255.0 tunn0
int et0/1
vrf forwarding FINANCE
ip address 10.22.22.1 255.255.255.252
wr
Verification:-
A computer screen with white text Description automatically generated

A computer screen with white text Description automatically generated

To block FTP traffic from the Branch 2 network on router R1 while allowing all other traffic, the commands
"access-list 101 deny tcp 10.0.2.0 0.0.0.255 host 10.0.101.3 eq ftp" and "access-list 101 deny tcp 10.0.2.0
0.0.0.255 host 10.0.101.3 eq ftp-data" are required. These commands specify an access control list that denies FTP (port 21) and FTP-data (port 20) traffic from the 10.0.2.0/24 network to the host 10.0.101.3, while the command "access-list 101 permit ip any any" allows all other traffic.

Perform this task to create a password security policy and to apply the policy to a specific user profile.
Device> enable
Device# configure terminal
Device(config)# aaa new-model
Device(config)# aaa common-criteria policy policy1
Device(config-cc-policy)# char-changes 4
Device(config-cc-policy)# max-length 20
Device(config-cc-policy)# min-length 6
Device(config-cc-policy)# numeric-count 2
Device(config-cc-policy)# special-case 2
Device(config-cc-policy)# exit
Device(config)# username user1 common-criteria-policy policy1 password password1 Device(config)# end