Free Access Cisco.350-501.v2024-09-07.q358 Practice Test (Page 34)

Question 161

Refer to the exhibit.

Refer to the exhibit. The ISP is implementing a new hosting-as-a-service solution for its business customers. Service accessibility must be unique and separate for each customer. The network architect must ensure that multiple paths toward the hosting-as-a-service solution are always available. Basic protection against traffic black-holing on the MPLS network is required in case of link failure. Which two actions must the engineering team perform to meet the requirements? (Choose two.)

A.Enable the VRF-Lite feature on router R4 and enable BGP address-family VPNv4.

B.Configure the fast-hello command under the IS-IS routing protocol with the BGP multipath 2 option enabled.

C.Create the hosting-as-a-service VRF on router R4 and configure It with the route target both 65123:88 command.

D.Configure the fast-reroute per-prefix command for the IS-IS protocol in the MPLS network and enable the BGP route-reflector feature on R2.

E.Configure the mpls Idp sync command in the MPLS network with the BGP additional-paths receive and additional-paths send options.

Question 162

Refer to the exhibit.

An engineer needs to implement this QoS policy on customer's network due to ongoing slow network issues. What will be the effect on the network when the engineer implements this configuration?

A.Traffic that is identified in the ciscopolicy class map will be remarked from IP precedence 1 to DSCP AF11 when it exits the pos0/2/0/0 interface.

B.Traffic that is identified in the ciscotest class map will be marked with IP precedence 1 when it exits the poso/2/0/0 interface.

C.Traffic that is identified in the ciscopolicy class map will be marked with IP precedence 1 when it enters the pos0/2/0/0 interface.

D.Traffic that is identified in the ciscotest class map will be remarked from IP precedence 1 to DSCP AF11 when it enters the pos0/2/0/0 interface.

Question 163

Refer to the exhibit. Router 1 is missing the route for the router 2 loopback 0.
What should the engineer change to fix the problem?

A.the wildcard mask network statement in OSPF of Router 2

B.the area numbers on Router 1 and Router 2 to be similar

C.the hello timers on Router 1 and Router 2 to be different

D.Router 1 to be an ABR

Question 164

Simulation1
Refer to the exhibit.

Question 165

Refer to the exhibit.

Routers R2 and R3 are Level 1/Level 2 IS-IS routers that redistribute 198 18.x.x/24 prefixes to routers R5 and R6 In the Level 1 area R2 Is to be the preferred router for all redistributed prefixes in the Level 1 are a. Which configuration sets this preference?