Free Access Cisco.350-601.v2024-11-21.q619 Practice Test (Page 13)

Question 56

A network engineer must enable port security on all cisco MDS series switches in the fabric. The requirement is to avoid the extensive manual configuration of the switch ports. Which action must be taken to meet these requirements?

A.Enable the auto-learning port security feature on a per-VSAN basis.

B.Activate CFS distribution and file auto-learning port security feature on a per-VSAN basis.

C.Activate CFS distribution and the auto-learning port security feature.

D.Enable the auto-learning port security feature.

Question 57

Refer to the exhibit. An engineer configures an FCoE connection between a Cisco UCS and a Cisco Nexus 9000 Series Switch. The UCS FI-A connects to the Nexus switch using interface e1/12. All relevant configurations have been completed on the Nexus switch to support FCoE deployment. Which action must be taken on Cisco UCS Manager to complete the configuration?

A.Create a Virtual Fibre Channel Interface.

B.Change the Transport Type to FCoE.

C.Trunk VLAN 500 on interface e1/12.

D.Configure an FCoE uplink interface.

Question 58

Cisco Nexus 9000 Series Switches are configured with LACP protocol and default aging timers. What is the impact on the LACP peer during an ISSU upgrade?

A.The LACP peer connection terminates.

B.The LACP peer session remains up.

C.The LACP peer renegotiates the adjacency.

D.The LACP peer connection resets.

Question 59

What are two capabilities of the Cisco Network Assurance Engine? (Choose two.)

A.It verifies the speed of network packet flows by using telemetry.

B.It predicts the network load on a data center.

C.It validates that devices comply with network security policies.

D.It ensures that network performance meets an SLA.

E.It predicts the impact of changes to the network.

Question 60

A network engineer repeatedly saves a configuration on Catalyst switches to NVRAM using the write memory command. What action should be taken to implement the same action on Nexus switches?

A.Use the write memory command to save the configuration.

B.Use the alias command to use the write memory command.

C.Use the exit command to leave the configuration mode and save the configuration automatically.

D.Use the wri command to use the copy running-config startup-config command.

Other Version: 2374Cisco.350-601.v2023-12-23.q325; 2037Cisco.350-601.v2023-02-23.q125; 1948Cisco.350-601.v2023-01-26.q127; 4945Cisco.350-601.v2022-05-20.q177; 2859Cisco.350-601.v2022-05-10.q129; 65Cisco.Trainingdump.350-601.v2022-01-01.by.nat.127q.pdf

Latest Upload: 203PaloAltoNetworks.NGFW-Engineer.v2026-05-01.q43; 302Nokia.4A0-113.v2026-05-01.q69; 263EC-COUNCIL.312-49v11.v2026-04-30.q214; 230Microsoft.MB-820.v2026-04-30.q101; 212Salesforce.MC-202.v2026-04-30.q57; 207BICSI.INSTC_V8.v2026-04-29.q53; 336NMLS.MLO.v2026-04-28.q82; 245NCARB.Project-Management.v2026-04-28.q27; 466EMC.D-AV-DY-23.v2026-04-27.q184; 1124ServiceNow.CSA.v2026-04-27.q483

Question 56

Question 57

Question 58

Question 59

Question 60

Download PDF File