Refer to the exhibit. Which feature set must be used to configure on switch 2 to establish a VSAN trunk between switch 1 and switch 2?

A network engineer must create a script to quickly verify IP reachability for multiple hosts using ping from the Cisco NX-OS switches.
The script should use the management VRF and exit the shell after execution.
Which script should be used to achieve this objective?

A network engineer must configure FCoE on an interface of a cisco MDS 9000 series switch. It should be used for mapping between Vlan 600 and Vsan 6. Drag and drop the commands from the bottom into their implementation order in the FCoE configuration. Not all commands are used.

Refer to the exhibit.

Which VLANs are capable to be assigned on vPC interfaces?

Refer to the exhibit. The Cisco Nexus Series Switches SW1, SW2, and SW3 are connected via Layer 2 copper interfaces. An engineer implements loop prevention standard IEEE 802.1w on each VLAN lo provide lasier recovery from network changes or failures. The Implementation has these requirements
* Interfaces that are connected to Layer 2 hosts must not receive STP BPDUs.
* The implementation must detect unidirectional links due to one-way traffic twisted-pair links
* Bridge assurance must be enabled between SW2 and SW3
* The Layer 2 domain must be protected from superior BPDUs that arrive from external switches.
Drag and drop the code snippets from the right onto the blanks in the code on the left to complete the configuration for SW3. Not all code snippets are used.