The configuration snippet in the image is a part of IKEv2 configuration where the name mangler is associated with the organizational unit (OU) "MANGLER". In Cisco's IKEv2 implementation, this specific configuration means that only an IKEv2 peer whose certificate has an OU attribute set to "MANGLER" can establish an IKEv2 Security Association successfully. This is a method of ensuring that only peers with certificates issued to a specific organizational unit can connect, enhancing security by limiting unauthorized access. The name mangler is a feature that allows the administrator to specify a string that must be present in the peer's certificate for authentication. The name mangler can be applied to any certificate field, such as common name (CN), organization (O), or OU. The name mangler can also be used to modify the peer's identity based on the certificate field, such as appending or prepending a string to the identity. The name mangler is configured under the IKEv2 profile using the command crypto ikev2 profile profile-name identity name-mangler name-mangler-name dn field-name. In this case, the name mangler is applied to the OU field of the peer's certificate. The other options are incorrect because they do not describe the effect of the name mangler configuration. Option A is incorrect because the name mangler does not affect the identity matching for the IKEv2 authorization policy. The identity matching is based on the peer's identity type and value, which can be different from the certificate field. Option C is incorrect because the name mangler does not encrypt the OU field of the peer's certificate. The OU field is part of the certificate's subject, which is not encrypted in the IKEv2 messages. Option D is incorrect because the name mangler does not set the OU field of the peer's certificate. The OU field is determined by the certificate authority (CA) that issues the certificate, and the name mangler only verifies or modifies the peer's identity based on the OU field. References : Configuring Internet Key Exchange Version 2, Internet Key Exchange Version 2 CLI Constructs, Tutorial: Setting up a certificate-based IKEv2 VPN connection (RSA)

The debug crypto isakmp sa command shows the status of the Internet Security Association and Key Management Protocol (ISAKMP) security associations (SAs). The output of this command indicates that the ISAKMP negotiation failed after several retransmissions. The most likely cause of this failure is a mismatch in the authentication key between the two peers. The authentication key is specified by the crypto isakmp key command and must be the same on both routers. If the authentication key is different, the ISAKMP messages cannot be decrypted and verified by the peers, resulting in an error. To fix this problem, the network administrator should verify and correct the authentication key on both routers and clear the existing ISAKMP SAs with the clear crypto isakmp sa command. References: 1, 2, 3, 4

Obviously, if you allow all traffic to these risky domains, users might access malicious content, resulting in an infection or data leak. But if you block traffic, you can expect false positives, an increase in support inquiries, and thus, more headaches. By only proxying risky domains, the intelligent proxy delivers more granular visibility and control.
The intelligent proxy bridges the gap by allowing access to most known good sites without being proxied and only proxying those that pose a potential risk. The proxy then filters and blocks against specific URLs hosting malware while allowing access to everything else.