Online Access Free 3605 Practice Test

A technician is adding the Virtual link Aggregation Control Protocol (VLACP)
configuration
to a Converged
Campus
Solution
where
all Ethernet Routing
Switches (ERSs) are directly connected without intermediary WAN transport
devices. What are two recommended configuration tasks?
(Choose two.)

• A.Configure
  all links to use a global reserved
  multicast
  MAC address
  for VLACP messages.
• B.For the SMLT links, configure the long timeout value.
• C.Configure all links to use the same timeout value.
• D.For the Inter Switch Trunks (1ST) links, configure the long time-out value.

When configuring a new Ethernet Routing Switch (ERS) 8000 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI. How is the ACLI interface obtained?

• A.Exit the CLI and choose ACLI at the interface manager prompt.
• B.Change the ACLI boot flag and save the boot configuration file.
• C.Change the interface type in the config.cfg file.
• D.Use the abort command and enter 'no' at the default interface.

What is the
underlying
dynamic
link state
routing
protocol
used for
the implementation of the Avaya Enterprise Fabric?

• A.IS-IS
• B.OSPFv3
• C.OSPF
• D.SPBV

A campus network requirement is to introduce Virtual Routing and Forwarding (VRF) in the existing Ethernet Routing Switch (ERS) 8000-based core. The technician has to configure VRF on the ERS 8000. Which statement represents the order for configuring a new VRF?

• A.Create a VRF, create a new VLAN, move the VLAN to the new VRF, and add an IP address.
• B.Create a VRF, add an IP address, create a new VLAN, and move the VLAN to the new VRF.
• C.Create a new VLAN, add an IP address, create a VRF, and move the VLAN to the new VRF.
• D.Create a VRF, create a new VLAN, add an IP address, and move the VLAN to the new VRF.

One of the switches in the Ethernet Routing Switch (ERS) stacks files and is replaced. The auto unit replacement (AUR) is enabled but the stack is not functioning properly. What is the problem?

• A.The stack has two switches with Force Stack disabled.
• B.The switches in the stack are not identical
• C.The switches in the stack are not running the same release of software
• D.the stack power was left on during the switch replacement.