Where can the user set the long-haul WT decoder parameter, when designing a network with EPT?
Correct Answer: C
The long-haul WT decoder parameter can be set in the NE parameters when designing a network with EPT. This parameter is used to adjust the sensitivity of the decoder and can help to improve the accuracy of the measurements for long-haul WTs. The Network Element (NE) parameters in EPT (Element Planning Tool) are used to configure various settings and options for the network elements in the network. The long-haul WT decoder parameter is one such setting that can be configured in the NE parameters section. The user can access the NE parameters by navigating to the NE Parameters menu within the EPT interface. The user can then select the appropriate network element and modify the settings as needed. This information can be found in the Nokia guide for EPT.
Question 7
What is the meaning of first, second, and third window in the optical fiber propagation context?
Correct Answer: B
In optical fiber propagation context, the first, second, and third window refer to different wavelength intervals where the WDM (Wavelength Division Multiplexing) optical transmission occurs. The first window is the lowest loss window and is typically in the range of 1300-1324nm. This is the most commonly used window for long-haul communications. The second window is the 1550 nm window and is the most widely used window for long-haul and ultra-long-haul communications. This window has a lower attenuation than the first window, but it also has more dispersion, which can limit the maximum transmission distance. The third window is the range of 1625-1675 nm, it is also called the L-band window. This window has lower attenuation than the first and second window but its usage is limited due to the high cost of equipment and lack of commercial devices. These windows are used in WDM systems to increase the capacity of the fiber by transmitting multiple channels of data at different wavelengths on the same fiber. A,C,D are not correct as they are not related to the meaning of first, second, and third window in the optical fiber propagation context. Reference: Nokia Optical Networking Fundamentals, Nokia Press (ISBN:978-1-4822-8109-4) https://www.nokia.com/networks/solutions/optical-networking/ https://en.wikipedia.org/wiki/Wavelength-division_multiplexing
Question 8
What is the purpose of the NFM-T node synchronization?
Correct Answer: B
This is done in order to keep the NFM-T database in sync with the nodes in the network. The synchronization process allows the NFM-T to keep track of any changes that are made to the nodes, such as new nodes added, nodes removed, and so on. By synchronizing the node database with the NFM-T, network administrators can ensure that their network is up to date and running efficiently.
Question 9
Which of the following statements is true about chromatic dispersion (CD)?
Correct Answer: C
Different wavelengths propagate at different speeds within the same media and therefore different colors travel in the fiber with different speed. This phenomenon is known as chromatic dispersion and causes light to spread out as it travels through the fiber over distance, leading to signal attenuation and distortion. The fiber attenuation does not introduce inter-channel interference, but it can cause attenuation of the signal. Different channels have different bandwidths, but this does not affect CD performance.
Question 10
What is a trail?
Correct Answer: B
A trail is a transparent transport of a client signal. A trail is a physical link between two points in an optical network, allowing for the transport of a client signal from one point to the other. It is a low-order signal, such as a 10G Ethernet or a Fibre Channel signal, encapsulated into a high-order container, such as a 40G or 100G signal. This allows for the transport of the client signal over longer distances, increasing the power budget of the optical link.