Explanation
The GMRE node address is the IP address for communication between network elements (NEs) in a GMPLS-controlled optical network. The GMRE node address is also known as the GMRE loopback address or the GMPLS node IP. It is used by GMPLS protocols such as LMP and RSVP to identify and communicate with other GMRE nodes. The GMRE node address is configured on each NE and is advertised by OSPF-TE to other nodes in the same area. References : Nokia 1830 PSS-4, PSS-8, PSS-16 and PSS-32 Platforms - NATO, 1830 PSS Identifiers

Explanation
The GMRE notify address is an IP address used to signal failures on downstream nodes upstream to the head node. The GMRE notify address is configured on each GMRE node and is used to send a Notify message to the head node when a failure occurs on a link or node alongthe LSP. The Notify message contains the failure information and the LSP ID. The head node can then initiate a restoration process based on the Notify message. References : Nokia GMPLS-controlled Optical Networks Course | Nokia, GMPLS - Nokia

Explanation
The SNC state with an uppercase "N" means that the resource is currently using the nominal resource assigned to it. As explained in the previous question, a nominal resource is the default or preferred resource that is assigned to an LSP when it is created. If an LSP is using the nominal resource on a TE-link, it means that the LSP has not been rerouted or switched due to any failure or constraint violation. In this case, the SNC state of the resource will be "N", indicating that it is in use by an LSP12. References:
* 1: Nokia GMPLS-controlled Optical Networks Course | Nokia
* 2: Nokia Network Functions Manager for Transport User Guide | Nokia

Explanation
GMPLS-enabled nodes use routing protocols, such as OSPF-TE or ISIS-TE, to exchange information about the topology and the state of the links in the network12. This information includes the link attributes, such as bandwidth, wavelength, protection, and shared risk link groups (SRLGs)3. The state of each link indicates whether it is up or down, available or reserved, and so on. This information is used by GMPLS-enabled nodes to compute feasible paths for LSPs and to avoid routing loops or conflicts. The bandwidth and the frequency of each client path are not present in every GMPLS-enabled node, but only in the ingress and egress nodes that initiate and terminate the LSPs. The list of LSPs created in the entire network is also not present in every GMPLS-enabled node, but only in the nodes that are involved in the LSPs or that maintain a global view of the network. References:
* 1: GMPLS - Nokia
* 2: Generalized Multi-Protocol Label Switching - Wikipedia
* 3: Nokia GMPLS-controlled Optical Networks Course | Nokia

Explanation
To configure the Trail template in NFM-T for an Uplink board (such as 2UC400) in a network with only LI restoration capability, you need to check the Logical Link box, set the Port Type to Unterminated, uncheck the ASON Routed box, and uncheck the ASON Tunnel box. This configuration allows you to create a logical link between two Uplink boards that can be used for LI restoration. The logical link is not terminated at the Uplink board, but at the OTU board. The ASON Routed option is not needed for LI restoration, as the LSPs are established by NFM-T and not by GMPLS. The ASON Tunnel option is not applicable for Uplink boards. References : Nokia Advanced Optical Network Management with NFM-T Course | Nokia, Nokia 1830 PSS-4, PSS-8, PSS-16 and PSS-32 Platforms - NATO