Online Access Free 500-007 Practice Test

What does an endpoint system use to navigate the Auto Attendant menu on the Cisco TelePresence MCU?

• A.only FECC; DTMF is not supported
• B.web interface of the endpoint
• C.FECC or DTMF navigation
• D.a special remote that came with the Cisco TelePresence MCU

What are two ways to set the IP network information on the Cisco TCS? (Choose two.)

• A.DHCP
• B.automatically assigned by the Cisco TelePresence Management Server
• C.statically set on its Windows operating system
• D.statically set on its Linux operating system

Where would you enter release and option keys into the Cisco TelePresence Management Suite?

• A.on the Cisco TelePresence Manager Suite server maintenance page
• B.through the release key generator in a terminal session on the server
• C.on the portal page
• D.in Configuration > General Settings

Which of these options shows the methods that are available to configure a Cisco VCS appliance at initial installation?

• A.using the Cisco Prime Collaboration Manager, after running 'system discovery' to discover the newly added Cisco VCS
• B.CLI over serial port, web interface, boot disk
• C.CLI over serial port, web interface, keyboard and monitor
• D.CLI over serial port, web interface, LCD panel

While on a call, using the remote control, how do you add an additional participant to a call on your MultiSite-enabled endpoint?

• A.Press the Home button to return to the menu, and select the Add Participant button.
• B.Press and hold the Call key to bring up the dialing menu.
• C.Press the Call key, and choose or dial the number of the additional participant.
• D.Press and hold the End Call key to bring up the dialing menu.