Online Access Free 500-171 Practice Test

Refer to the exhibit.

Which is correct for configuring FCoE?

• A.fcoe vlan 33int po11switchport trunk allowed vlan add 33vsan databasevsan 33
• B.fcoe vsan 43int po11switchport trunk allowed vsan add 43vsan databasevsan 43
• C.vlan 33fcoe vsan 43int po21switchport trunk allowed vsan add 43int vfc11bind interface po21vsan databasevsan 43 interface vfc 11
• D.vlan 33fcoe vsan 43int po11switchport trunk allowed vlan add 33int vfc11bind interface
  po11switchport trunk allowed vsan 43vsan databasevsan 43 interface vfc11
• E.fcoe vsan 43int po21switchport trunk allowed vsan add 43vsan databasevsan 43

Which tool can be used to validate hardware installation in a FlexPod solution?

• A.NetApp OnCommand Unified Manager
• B.NetApp Config Advisor
• C.Cisco UCS Director
• D.Cisco UCS Central
• E.NetApp OnCommand Insight

When installing an instance of VMware ESXi on a UCS B-Series server, where should an ISO image be loaded?

• A.Only physical install disks are supported on UCS B-Series servers
• B.The UCS vCenter Plugin must be used
• C.ISO images should not be used
• D.From the UCS Manager select KVM Console, Select the Virtual Media tab, and select Add Image

Your primary VSM needs to be edited, rebooted, or migrated. You need to initiate a manual switchover to your standby VSM. What command will allow this to occur?

• A.System standby
• B.vsm switchover
• C.Standby activate
• D.System switchover

Which two LIFs are able to failover or migrate to other nodes in the cluster? (Choose two.)

• A.data LIF of protocol NFS
• B.node management LIF
• C.data LIF of protocol CIFS
• D.intercluster LIF
• E.data LIF of protocol FCoE
• F.cluster LIF
• G.data LIF of protocol iSCSI