Online Access Free 500-201 Practice Test

Which statement about pseudowire is true?

• A.Pseudowire is set up between the CEs at two different customer sites to emulate a customer's T1 or E1 circuit.
• B.Pseudowire is set up between PEs that serve two different customer sites to emulate a customer's T1 or E1 circuit.
• C.Pseudowire eliminates the need for MPLS on a service provider core network.
• D.Pseudowire is used only to emulate T1 and E1 leased line services between customer sites.

In the aggregation or pre-aggregation nodes, which interfaces have MPLS enabled on them with the MLPS IP command?

• A.Ethernet interfaces
• B.router ID loop backs only
• C.all loop backs
• D.services instances

What is the purpose of the next-hop-self command in the BGP configuration on a Cisco ASR 9000?

• A.to extend the iBGP hierarchical LSP across IGP/LDP domains
• B.to improve routing performance by allowing faster routers to take on all the routing
• C.to allow for a single AS across the architecture
• D.to stop the router for passing traffic

Which command would set up the primary clock interface for a Cisco ASR 901?

• A.Router(config)# synce state master int gig 0/1
• B.Router(config-if)# synce master state
• C.Router(config-if)# synce state master
• D.Router(config)# synce master state int gig 0/1

Which function is configured to enable interdomain transport via BGP?

• A.multi-exit discriminator)
• B.community filtering
• C.next-hop-self
• D.local preference