Online Access Free 600-601 Practice Test

In which two ways could you minimize the impact of monitoring an industrial network? (Choose two.)

• A.Do frequent ping sweeps to industrial devices to check for their proper operations.
• B.Make a copy of all the network traffic and analyze it offline.
• C.Send random messages to a device and see what the response is.
• D.Use an industrial-network-grade IDS-IPS system.

Exhibit:

Refer to the exhibit. Host 3 on Network A is sending data to Host 8 on Network B.
Which address is the default gateway of Host 3?

• A.the address of the router interface Fa0/0
• B.the address of the switch interface that is connected to router interface Fa0/0
• C.the address of the host that is connected to Network B
• D.the address of the switch interface that is connected to router interface Fa0/1
• E.the address of the host that is connected to Network A
• F.the address of the router interface Fa0/1

Given a ring topology, which loop prevention mechanism provides the fastest reconvergence time after a link failure?

• A.Multiple Spanning Tree Protocol
• B.Resilient Ethernet Protocol
• C.Spanning Tree Protocol
• D.Rapid Per-VLAN Spanning Tree Protocol

What are two symptoms of duplex mismatch? (Choose two.)

• A.Communication is slow and locks up.
• B.The full-duplex side sees CRC errors.
• C.Speed is seen equally slow in both directions.
• D.Ping does not return from one direction versus the other direction.
• E.The half-duplex side sees frame sequence errors or runt frames.

Exhibit: Refer to the exhibit. A technician enters the exhibited commands to configure a new router on the plant floor, but receives an error message when attempting to save the configuration. What can the technician do to correct the problem?

• A.Upgrade the amount of flash memory in the router.
• B.Enter the command at the correct prompt.
• C.Erase NVRAM to make room for the configuration file.
• D.Enter the correct command.
• E.Add NVRAM because there is not enough room for the configuration file.