Online Access Free 6101-1 Practice Test

After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST
What are two causes of the IST not running properly? (Choose two)

• A.The IST is not enabled on both switches.
• B.The peer IP addresses have to be 192.168.1.1/30 and 192.168.1.2/30.
• C.The MLT ID does not match on both switches.
• D.The peer IP address is not the address of the peer switch IST VLAN.

A technician wants to use the New Unit Quick Configuration feature to add new units to a stack of Ethernet Routing Switch (ERS) 5000 switches without. As well as enabling the feature, what else must be done to use the New Unit Quick Communication feature?

• A.Apply the feature license
• B.Save a template on the base unit
• C.Insert a new switch in the stack
• D.Save a template on the backup unit

An Ethernet routing switch (ERS) 4550T-PWR has been deployed with a single AC power supply and is currently supporting 20 VoIP telephones with power over Ethernet (PoE). each with a power draw of 8 Watts when offhook.The network engineer has requested the addition of 5 Wireless Access points (WAPs) to the ERS 4550T-PWR.Each WAP supports PoE and requires 12 Watts of power.
What is the outcome of the addition of the WAPs to the ERS 455QT-PWR?

• A.The addition of a Redundant Power Supply 15 will be required to provide sufficient power to ensure the VoIP phones and WAP function property.
• B.The 4550T-PWR will have sufficient power to support the 20 VoIP telephones and 5 WAP devices,
• C.The addition of a second AC power supply will be required to provide sufficient power to the ERS -4550T-PWR to Support all of-the PoE devices.
• D.the power requirement of the WAP exceeds the individual port maximum power rating of the ERS 4550T-PWR and will therefore require an external power source.

A technician is configuring an Ethernet Routing Switch (ERS) 5520-24T for the edge of the Converged Campus network. in band communication to edge switch is a customer design requirement.
Which two VLANS are acceptable VLANs to use for the switch/stack IP addresses? (Choose two)

• A.default
• B.data
• C.voice
• D.management

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly connected without intermediary WAN transport devices
What are two key configuration tasks? (Choose two)

• A.For the 1ST links, configure the long timeout value
• B.Configure all links to use a unique reserved multicast MAC address for VLACP messages
• C.configure all links to use the default multicast MAC address for VLACP messages
• D.For the SMLT links, configure the long timeout value