Online Access Free 6101.1 Practice Test

In a newly installed network the port LED on an Ethernet Routing Switch (ERS) 5500 is amber, not green. What does this mean?

• A.The port is set to operate at 10 Mbps.
• B.The port is set to operate at 100 Mbps.
• C.It indicates that the port is administratively disabled.
• D.It indicates that there is a transmit fault.

Avaya recommends using RSMLT edge in place of VRRP with Backup Master, when available what are two valid reasons for using RSMLT edge? (Chouse two)

• A.RSML T dynamically balances the CPU load across the switch cluster.
• B.RSMLT edge allows the cluster to be configured to discard untagged frames in 1ST and SMLT ports.
• C.RSMLT edge is easier to configure and lightens the CPU load,
• D.RSMLT edge provides support for application where more than 255 redundant default gateways (VRRP limit) need to be provided.
• E.the VRRP hold down timer cannot be set high enough to update the complete routing table when Layer 2 access requirements are high.

When configuring Ethernet Routing Switch (ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI.
How is the ACLI interface obtained?

• A.Use the abort command and enter "no" at the default interface prompt
• B.exits the CLI and chooses ACLI at the interface manager prompt.
• C.Change the ACLI boot flag and save the boot configuration file.
• D.Change the interface type in the config.cfg file.

With release 4.0 or higher software on the Ethernet routing switch (ERS) 8300, an advanced routing license is required to enable certain features.
Which two statements ant true about the Advanced Routing License process and supported features for the ERS 8300? (Choose two.)

• A.the Advanced Routing License supports QoS, SMLT, VRRP and OSPF
• B.To protect against security breaches, the ERS 8300 allows only a primary path for the license file
• C.To protect against system flash failure, the ERS 8300 allows a primary, secondary, and tertiary path for the license file.
• D.the Advanced Routing License supports SMLT, VRRP, OSPF, PIM-SM. and SLPP

A technician has implemented RSMLT edge design. After recovering from a power outage some clients could not communicate. It has been determined that only one of the core RSMLT switches has recovered.
What should have been done to prevent the loss of communications?

• A.Set the VLAN to copy RSMLT into from a similarity configured VLAN.
• B.Turn on the HoIdDown timer
• C.Clear the peer IP and MAC addresses
• D.Increase the Holdup timer to 9999